The
model 9528 Pulse Generator takes pulse generator and digital
delay technology to new levels. Cost effective, yet extremely
capable, this instrument provides solutions to generate and
synchronize multiple pulses and triggers for a wide variety
of applications from simple to complex.
The 9528 provides up to eight fully independent
digitally controlled channels having width, delay, rate and
amplitude control on each output. For automated test sequencing,
all common computer interfaces are available such as RS232,
USB, GPIB and Ethernet.
Key Features:
Internal rate generator >> T0
period adjustment provides finer adjustment than pure rate
Complete channel and system setup stored in memory>>
Provides 14 memory configurations
Remote programmability >> All of the 9520 series
instruments offer RS232, GPIB, USB and Ethernet
Single cycle pulse by pushbutton or reference trigger
>> One pulse with each pushbutton, internal, external
signal or software command
250ps timing resolution with < 200ps jitter
Dual inputs (gate and/or trigger)
Channel Properties - Advanced Programming
Modes:
Multiplexing>> Selectively combine
the timing of any or all channels to one output
Burst>> Each channel can have a separate number
Duty Cycle>> N pulses on, M pulses off
Channel Referencing>> Any or all channels can reference
the timing of any channel rather than T0, rising or falling
edge, with either positive or negative reference
Wait>> The system will wait for a specified number
of cycles before producing pulse
Base Price: $5,160.00
Options: (* Note: System is
configured in 2 channels per module)
- 820nm Optical Output Module with ST connectors
- add $220 per module
- 1300nm Optical outputs with ST connectors - add $220 per module
- TTL/35V High Voltage Module - add $220 per module
- 50 Ohm Impedance Matched TTL (4V) Output/Input Options - $150
per module
- 820nm Optical inputs available with ST connectors - add $220
per module
- 1300nm Optical inputs with ST connectors - add $220 per module
- Pulse Increment Option - add $250
- Add GPIB and Ethernet communication - add $375
- Add additional trigger/gate option via gate input - add $170
Accessories:
- Single Rackmount - $250
- Double Rackmount - $250
Complimentary Universal LabVIEW driver available